Sign Frames
Sign Frames8 Different Sign Frames to suit all applications All Sign Frame sections are Supplied in five metre lengths, or cut and mitered, |
 |
UNITRIM- similar to panatrim. Can be use with front or rear hanging rails. All the tried and tested features of uniframe with a more traditional appearance including our unique screw port and corner plate facility. (corner plate facility holds the frame square in particular while in transit) |
 |
PETITE - Designed for panels up to 450mm (18") deep. Ideal for covering shutter boxes. Neat enough to create a 200 x 75mm door sign. Also including our unique screw port and corner plate facility. |
 |
ROLLERBEAD - is our unique Two-Piece frame capable of housing panels single or double from 3mm to over 25mm thick. It loads from the front and therefore fits into apertures where no other frame would go! (See our page on Light Boxes for further details). |
|
|
UNIFRAME- Original and Bullnose is a very popular frame, commonly used for the average shop fascia. Recommended use up to 3ft (1m maximum). All SMP frames have our unique screw port facility and corner plates. |
 |
ULTIMATE UNIFRAME- Our all singing, all dancing Rolls Royce frame. Has all the attributes of Uniframe and the addition of corner cleats for permanent mitre closure. The lower pocket will accept (Soldiers) struts to hold the frame together whilst transporting assembled frames. Use enough Soldiers and they can be used as a fixing point. ie. Fixing signs onto canopies that are smaller than the sign. Another unique use of this pocket, as an alternative to the above, is for a stiffening bar on the back of the panel. (See diagram).  This system renders the sign virtually impossible to blow out of the frame without first breaking the sign panel. |
 |
POST FRAME - was created for In Store Directories, Swing signs: and small free-standing forecourt signs. The appearance is the same on the back as on the front. The Glazing pocket is 7mm thus allowing 2 x 3mm panels back to back. |
 |
DOOR FRAME- Is another very useful frame. Create a door frame to fit over anything, eg. a Light Box, another Frame, MDF Panels, Notice Boards or Folded Trays, are some examples. Acrylic or Polycarbonate Panels are bonded into pocket "A". Cleats in pocket "B" and screws into our unique screw port creates a very strong door frame. We have developed a small push lock with security key to make access quick and easy to almost all applications. As most SMP extrusions, this product is available in Silver Anodised or White Powder Coated. |
 |
SNAP SHUT FRAME- used for advertising where you need the ability to change your signage easily with out messing around with beading screws. |
 |
CORNER JOINT - for joining corners designed to accommodate 3mm substrates can be adapted to 5mm. |
 |
EDGE FIXING - Can be curved to fit round shop facias |
 |
EDGE PROTECTOR - for trim around Site Boards, etc. |
 |
PANEL JOINT - Used for joining panels leaves a nice neat finish |
|
|
SMP RETURNS Why not make you own Sign Trays using our unique returns system. They are available in red black blue green silver or white in 50mm and white in 100mm. No routing mess just mitre the corners and use an angle cleat and some high quality VHB tape. they can even be used to make shaped trays with rounded corners etc |
 |
CORNERS SMP Corners can be used instead of mitering your frame. They are specially designed to fit our unitrim frame section. The actual corner is injection molded and comes in 3 different shapes 90 degree, rounded and escalloped. A neat way of making an atractive sign frame. |
